Lancom ES-2126+ Manual page 39

LANCOM ES-2126+ und LANCOM ES-2126P
Chapter 4: Operation of Web- based Management
38
time since it passed over. And when the time passes over the ending
time, the system time will be decreased one hour after one minute at
the time since it passed over.
The switch supports valid configurable day light saving time is –5 ~
+5 step one hour. The zero for this parameter means it need not have
to adjust current time, equivalent to in-act daylight saving. You don't
have to set the starting/ending date as well. If you set daylight saving
to be non-zero, you have to set the starting/ending date as well;
otherwise, the daylight saving function will not be activated.
Default for Daylight Saving: 0.
The following parameters are configurable for the function Daylight
Saving and described in detail.
Day Light Saving Start :
This is used to set when to start performing the day light saving time.
Mth:
Range is 1 ~ 12.
Default: 1
Day:
Range is 1 ~ 31.
Default: 1
Hour:
Range is 0 ~ 23.
Default: 0
Day Light Saving End: This is used to set when to stop performing the
daylight saving time.
Mth:
Range is 1 ~ 12.
Default: 1
Day:
Range is 1 ~ 31.
Default: 1