Lancom ES-2126+ Manual page 49

LANCOM ES-2126+ und LANCOM ES-2126P
Chapter 4: Operation of Web- based Management
48
State: Show that the communication function of the port is "Enabled"
or "Disabled". When it is enabled, traffic can be transmitted and
received via this port. When it is disabled, no traffic can be transferred
through this port. Port State is configured by user.
Default: Enabled.
Auto Nego.: Show the exchange mode of Ethernet MAC. There are
two modes supported in the switch. They are auto-negotiation mode
"Enabled" and forced mode "Disabled". When in "Enabled" mode,
this function will automatically negotiate by hardware itself and
exchange each other the capability of speed and duplex mode with
other site which is linked, and comes out the best communication
way. When in "Disabled" mode, both parties must have the same set-
ting of speed and duplex, otherwise, both of them will not be linked.
In this case, the link result is "Down".
Default: Enabled
Speed / Duplex : Display the speed and duplex of all port. There are
three speeds 10Mbps, 100Mbps and 1000Mbps supported for TP
media, and the duplex supported is half duplex and full duplex. If the
media is 1Gbps fiber, it is 1000Mbps supported only. The status of
speed/duplex mode is determined by 1) the negotiation of both local
port and link partner in "Auto Speed" mode or 2) user setting in
"Force" mode. The local port has to be preset its capability.
In port 1 – 24, they are supported Fast Ethernet with TP media only,
so the result will show 100M/Full or 100M/Half, 10M/Full and 10M/
Half duplex.
In port 25 and port 26, if the media is 1000Mbps with TP media, it
will show the combinations of 10/100M and Full/Half duplex,
1000Mbps and Full duplex only. If the media is 1000Mbps with fiber
media, it will show only 1000M/Full duplex.
Default: None, depends on the result of the negotiation.
Rx Pause: The way that the port adopts to process the PAUSE frame.
If it shows "on", the port will care the PAUSE frame; otherwise, the
port will ignore the PAUSE frame.
Default: None
Tx Pause: It decides that whether the port transmits the PAUSE frame
or not. If it shows "on", the port will send PAUSE frame; otherwise,
the port will not send the PAUSE frame.