Table of Contents
Advertisement
13.3 Operation
13.3.1
Settings up to LCD Display
To perform LCD display, the hardware and software related items described below must first be
determined.
1.
Hardware settings
a. Using 1/2 duty
When 1/2 duty is used, interconnect pins V
Figure 13-3 Handling of LCD Drive Power Supply when Using 1/2 Duty
b. Large-panel display
As the impedance of the built-in power supply split-resistance is large, it may not be
suitable for driving a large panel. If the display lacks sharpness when using a large panel,
refer to section 13.3.7, Boosting the LCD Drive Power Supply. When static or 1/2 duty is
selected, the common output drive capability can be increased. Set CMX to 1 when
selecting the duty cycle. In this mode, with a static duty cycle pins COM
output the same waveform, and with 1/2 duty the COM
COM
and COM
2
c. Luminance adjustment function (V
Connecting a resistance between the V
For details, see 13.3.3, Luminance Adjustment Function (V
d. LCD drive power supply setting
With the H8/3867 Series, there are two ways of providing LCD power: by using the on-
, and the COM
waveform is output from pins COM
1
2
pin)
0
and V
as shown in figure 13-3.
2
3
V
CC
V
0
V
1
V
2
V
3
V
SS
waveform is output from pins
1
and V
pins enables the luminance to be adjusted.
0
1
336
to COM
4
and COM
4
Pin).
0
1
.
3
Advertisement
Table of Contents
