Grounding; Network Setup - Cardiac Science Atria 6100 Operating Instructions Manual

Grounding

Network Setup

70-00082-01 A
All connected equipment must be IEC 60950 approved or equivalent.
Consult a qualified technician to verify equipment compatibility.
The following communication options require network setup:
• Email
• Printing to network printers
• Sending to EMR via network connection
• Sending to shared location on network
NOTE: Press [ALT] + [H] to access the
Network Setup
Atria Network Configuration
The facility network must be set up before connecting the Atria to the
network. Use these instructions to configure Ethernet and 802.11
networks.
1. Press [Home] and then press [Setup].
2. Select
Send Receive
ETHERNET CONNECTION SETUP
To set up the network using an RJ-45 Ethernet connection
1. Select
Network Type
• (Recommended) Select
assignment.
• Select for fixed IP address assignment.
OFF
2. Enter the following:
a. When DHCP is
-
IP address
assigned by the network administrator.)
-
Subnet Mask
-
Gateway
for additional information.
>
Setup Network Connection
> >
Ethernet Use DHCP
for dynamic IP address
ON
enter:
OFF
(IP Address for the Atria, typically
(typically 255.255.255.0).
(IP address for the Gateway.)
Atria Electrocardiograph Operating Instructions
Grounding
menu. Select
Help
.
:
5-3