Parameterization - Siemens SIMOVERT MASTERDRIVES Operating Instructions Manual

10.99
8

Parameterization

Examples
Siemens AG 6SE7087-6KP50
SIMOVERT MASTERDRIVES
The functions stored in the units are adapted to your specific
application by means of parameters. Every parameter is clearly
identified by its parameter name and its parameter number. In addition
to the parameter name and number, many parameters also have a
parameter index. These indices enable several values to be stored for a
parameter under one parameter number.
Parameter numbers consist of a letter and a three-digit number. The
upper-case letters P, U, H and L represent the parameters which can
be changed, and the lower-case letters r, n, d and c represent the
visualization parameters which cannot be changed.
DC Bus Volts r006 = 541
Src ON/OFF1 P554.2 = 20
Parameters can be input as follows:
♦ Via the PMU parameterizing unit which is permanently mounted on
the front of the units,
♦ Via the user-friendly optional OP1S operator control panel or
♦ Via a PC and the SIMOVIS service program.
The parameters stored in the units can only be changed under certain
conditions. The following preconditions must be satisfied before they
can be changed.
♦ The parameter must be a changeable parameter. (Designated by
upper-case letters in the parameter number).
♦ Parameter access must be granted.
(P053 = 6 for parameterizing via the PMU or the OP1S).
♦ The unit must be in a status which permits parameters to be
changed. (Carry out initial parameterization only in powered-down
status).
♦ The lock and key mechanism must not be activated
(Deactivation by parameter reset to factory setting).
Operating Instructions
Parameter name: DC Bus volts
Parameter number: r006
Parameter index: Does not exist
Parameter value: 541 V
Parameter name: Src ON/OFF1
Parameter number: P554
Parameter index: 2
Parameter value: 20
Parameterization
8-1