Parameterizing With Parameter Modules - Siemens SIMOVERT MASTERDRIVES Operating Instructions Manual

10.99
8.5

Parameterizing with parameter modules

NOTE
Siemens AG 6SE7087-6KP50
SIMOVERT MASTERDRIVES
After the data set to be downloaded has been selected, if the
identification of the stored data set does not agree with the identification
of the connected unit, an error message appears for approximately 2
seconds. The operator is then asked if downloading is to be
discontinued.
É Ë
P
Download Download
*1909199701 *1909199701
MASTERDRIVES MC MASTERDRIVES MC
PLUS PLUS
Yes: Downloading is discontinued.
No: Downloading is carried out.
Pre-defined, function-assigned parameter modules are stored in the
units. These parameter modules can be combined with each other, thus
making it possible to adjust your unit to the desired application by just a
few parameter steps. Detailed knowledge of the complete parameter
set of the unit is not required.
Parameter modules are available for the following function groups:
1. Motors
2. Motor encoders
3. Control types
4. Setpoint and command sources
Parameterization is effected by selecting a parameter module from
each function group and then starting quick parameterization.
Depending on your selection, the necessary unit parameters are set to
produce the desired control functionality. The parameters necessary for
fine adjustment of the control structure are automatically adopted in the
user menu.
If parameter changes have already been carried out on the unit, it is
recommended that you carry out a parameter reset to the factory
setting prior to performing "Quick parameterization".
Operating Instructions
É Ë É
P 2 s
Error: MotionControl 00
Different
IDs #yes
Parameterization
Ë
Stop download?
no
8-11