Configuring Ancp Rate Adjustment - Cisco ASR 9000 Series Configuration Manual

How to Configure ANCP on Cisco ASR 9000 Series Routers
Command or Action
Step 5
show ancp an-port [configured |
dynamic-only][statistics]
Example:
RP/0/RSP0/CPU0:router# show ancp an-port
configured
Step 6
show ancp an-port summary
[statistics][detail]
Example:
RP/0/RSP0/CPU0:router# show ancp an-port
summary
Step 7
clear ancp an-port {all | circuit-id
Access-Loop-Circuit-Id | interface type
instance | neighbor {description string |
sender-name { H.H.H | A.B.C.D }}[statistics]
Example:
RP/0/RSP0/CPU0:router# clear ancp an-port
all
Step 8
show ancp an-port {description
description-string | sender-name { H.H.H |
A.B.C.D }}
Example:
RP/0/RSP0/CPU0:router# show ancp an-port
description vendor3b
Step 9
show ancp an-port state [up | down | none]
[statistics]
Example:
RP/0/RSP0/CPU0:router# show ancp an-port
state up

Configuring ANCP Rate Adjustment

Use the ancp rate-adjustment command to apply a mathematical correction to the ANCP rate update
prior to applying it as a shaper rate.
SUMMARY STEPS
1.
2.
3.
4.
Cisco ASR 9000 Series Aggregation Services Routers Modular Quality of Service Configuration Guide
QC-90
D r a f t — C i s c o C o n f i d e n t i a l
configure
ancp rate-adjustment dsl-type access-loop-type percent-factor factor
end
or
commit
show ancp summary detail
Configuring Access Node Control Protocol on Cisco ASR 9000 Series Routers
Purpose
(Optional) Displays summary data or statistics for
AN ports that are or are not mapped to interfaces.
(Optional) Displays port counts by state.
(Optional) Clears AN ports of dynamic data or
statistics either individually or in groups.
Published information is cleared and information
learned from the DSLAM is cleared.
(Optional) Displays AN port information.
(Optional) Displays AN port state information.
OL-17239-01