Endress+Hauser Proservo NMS5 Operating Instructions Manual page 45

Proservo NMS5
Endress+Hauser
Key
• Access to the programming matrix (touch the key for 3 seconds or more).
• Return to HOME position (touch the key for 3 seconds or more).
• Move the status horizontally in the function group to select functions.
• Save parameters or access codes.
• Move the status vertically to select function groups.
-
• Selec or set parameters.
• Set access codes.
Note!
LCD returns to HOME position when no key is touched for 10 minutes or more. Digits are incremented or
decremented using by + or - key. When touching + or - key continuously, then the minimum digit changes
first. After one cycle of the minimum, the second minimum changes. After one cycle of the second follows the
third minimum, and so on. When releasing a finger from the touch control, then the procedure starts again
from the minimum digit (Analogy of mechanical counter).
LCD ( HOME Position)
When touching
"E" on the matrix
for 3 seconds or
longer, the screen
moves to V0
position.
0
0
1
2
3
9 INTERFACE PROFILE
4
V
4
5
5
6
6
7
7
8
8
9
9
Figure. 49: Selection Matrix Groups, Function Groups, and Functions with Programming Matrix
Functions
When touching on the matrix for 3 seconds or longer,
the screen returns to HOME position.
> 3 s
H
4
1 2 3 5
8 TANK PROFILE
4 7 ADJ. SENSER
4
6 HART DEVICE(2)
5
5 HART DEVICE(1)
4
5
6
4 4 TEMPERATURE
5
6
7
4
5
6
7
8
5
6
7
8
9
6
7
8
9
7
8
9
8
9
9
6
7 8 9
MATRIX OF G0 V3H0
1 CALIBRATION
2 DEVICE DATA
3 SERVICE
4 TEMPERATURE
5 HART DEVICE (1)
6 HART DEVICE (2)
7 ADJ. SENSOR
8 TANK PROFILE
9 INTERFACE PROFILE
3 SERVICE
4 2 DEVICE DATA
1 CALIBRATION
5 4
6
5
7
6
8
7
8
9
9
6 Operation
45