Home Position - Endress+Hauser Proservo NMS5 Operating Instructions Manual

6 Operation
46
6.2

HOME Position

After turning on the power, LCD shows the current data on HOME position.
Figure. 50: HOME Position
The letters A, B, C and D stand for the areas where information on measured values and status of the device
are displayed:
Area
A
B
C
D
The meanings of message appearing on LCD (display) is explained in the following table.
Gauge Status
G - RE Reference position for measuring
UP The measuring wire is hoisted.
STOP The measuring wire stops.
LIQU The liquid is being measured.
U - IF The upper interface level is being measured.
LIF The lower interface level is being measured.
BOTM The tank bottom level is being measured.
U - DE The upper liquid density is being measured.
M - DE The middle liquid density is being measured.
B - DE The bottom liquid density is being measured.
CAN Resetting RELE.OVER TENS (over tension error).
TEAC Calibration is being measured.
blank Measuring is not possible.
Information
Current Level
Current Temperature
Gauge Status
Displacer Status
Description
Proservo NMS5
Endress+Hauser