Setting The Record Length; Starting/Stopping The Can Bus Signal Acquisition - YOKOGAWA DL7480 User Manual

2.4 Setting CAN Bus Signal Acquisition Conditions

Setting the Record Length

Starting/Stopping the CAN Bus Signal Acquisition

2-18
The record length sets the amount of data to be written into the acquisition memory. The
selectable maximum record length varies depending on the model.
16 MW memory model (701460 and 701480)
1 k, 10 k, 50 k, 100 k, 250 k, 500 k, 1 M, 2 M, 4 M, 8 M (, 16 M)
4 MW memory model (701450 and 701470)
1 k, 10 k, 50 k, 100 k, 250 k, 500 k, 1 M, 2 M (, 4 M)
* The value inside the parentheses is selectable only when interleave mode is ON.
For details on the record length, see section 7.2, "Setting the Record Length" in the
DL7440/DL7480 User's Manual (IM701450-01E) . For details on interleave mode, see
section 7.3, "Using Interleave Mode."
When you start the CAN Bus signal acquisition, triggers are activated on the specified
trigger conditions.
To proceed to the analysis, you stop the CAN Bus signal acquisition.
IM 701450-51E