Setting The Trigger Level, Trigger Coupling, Etc; Setting The Trigger Mode; Setting The Record Length; Starting/Stopping The I 2 C Bus Signal Acquisition - YOKOGAWA DL7480 User Manual

Setting the Trigger Level, Trigger Coupling, Etc.

Setting the Trigger Mode

Setting the Record Length

Starting/Stopping the I
IM 701450-51E
Note
If you set Combination to I
on the DL7440) to all Xs, triggers will not be activated. If the clock channel is set to any of the
channels from CH3 to CH8 (CH3 and CH4 on the DL7440), the pattern conditions of other
channels are always set to true.
29. Press the Level/Coupling soft key. The Level/Coupling dialog box opens.
30. Set the trigger level, trigger hysteresis, trigger coupling, and HF rejection of
each channel. For the setup procedure, see steps 9 to 14 on page 6-16 in the
DL7440/DL7480 User's Manual (IM701450-01E) .
31. Press ESC. The Level/Coupling dialog box closes.
32. Set the trigger mode according to the procedures given in section 6.1, "Setting
the Trigger Mode" in the DL7440/DL7480 User's Manual (IM701450-01E) .
33. Set the record length according to the procedures given in section 7.2, "Setting
the Record Length" in the DL7440/DL7480 User's Manual (IM701450-01E) .
2
C Bus Signal Acquisition
34. Press START/STOP to start the I
activated on the specified trigger conditions.
To proceed to the analysis, press START/STOP to stop the I
acquisition.
2
1.4 Setting the I C Bus Signal Acquisition Conditions
2
C -> Pattern and set the patterns of CH3 to CH8 (CH3 and CH4
2
C Bus signal acquisition. Triggers are
1
2
C Bus signal
1-9