Setting The Trigger Level, Trigger Coupling, Etc; Setting The Trigger Mode; Setting The Record Length; Starting/Stopping The Spi Bus Signal Acquisition - YOKOGAWA DL7480 User Manual
Digital oscilloscope
serial bus signal analysis function
(includes the i2
c bus signal/can bus signal/
spi bus signal analysis function)
Hide thumbs
Also See for DL7480:
- User manual (55 pages) ,
- User manual (501 pages) ,
- Operation manual (29 pages)
Table of Contents
Advertisement
3.4 Setting SPI Bus Signal Acquisition Conditions
Setting the Trigger Level, Trigger Coupling, Etc.
Setting the Trigger Mode
Setting the Record Length
Starting/Stopping the SPI Bus Signal Acquisition
3-10
27.
Press the Level/Coupling soft key. The Level/Coupling dialog box opens.
28.
Set the trigger level, trigger hysteresis, trigger coupling, and HF rejection of
each channel. For the setup procedure, see steps 9 to 14 on page 6-16 in the
DL7440/DL7480 User's Manual (IM701450-01E) .
29.
Press ESC. The Level/Coupling dialog box closes.
30.
Set the trigger mode according to the procedures given in section 6.1, "Setting
the Trigger Mode" in the DL7440/DL7480 User's Manual (IM701450-01E) .
31.
Set the record length according to the procedures given in section 7.2, "Setting
the Record Length" in the DL7440/DL7480 User's Manual (IM701450-01E) .
32.
Press START/STOP to start the SPI Bus signal acquisition. Triggers are
activated on the specified trigger conditions.
To proceed to the analysis, press START/STOP to stop the SPI Bus signal
acquisition.
IM 701450-51E
Advertisement
Table of Contents
