3.7
Error Messages
Code
Message
37
Aborted the analysis.
38
Data not detected.
Execute again after changing the setting or
reacquiring the waveform.
739
Analyzed data does not exist.
Execute the analysis.
870
Cannot be specified. Invalid byte or bit.
871
Cannot be set when CS channels are not
specified.
IM 701450-51E
A message may appear during operation. This section describes the meanings of the
messages and their corrective actions. This section lists only the error messages related
to the SPI Bus signal analysis function. There are other error messages related to the
DL1740 and communications. These messages are described in the DL7440/DL7480
User's Manual (IM701450-01E) and the DL7440/DL7480 Communication Interface
User's Manual (IM701450-17E) .
You can set the messages to be displayed in English or Japanese. For the procedure of
setting the message language, see section 15.1, "Changing the Message Language and
Turning ON/OFF the Click Sound" in the DL7440/DL7480 User's Manual (IM701450-
01E) .
If the corrective action requires servicing, contact your nearest YOKOGAWA dealer for
repairs.
Action
–
–
Execute the analysis.
Increase the number of bytes.
–
3
Page
3-26
3-5, 3-11,
3-24, 3-30
3-26, 3-32
3-6, 3-12
3-25, 3-31
3-39