Tektronix TDS7000 Series Programmer's Manual page 528

Gpib programmer online guide digital phosphor oscilloscopes

Hide thumbs Also See for TDS7000 Series:

Table of Contents

*PSC Command

The *PSC command controls the Enable Registers contents at power-on. Sending *PSC 1 sets the

Enable Registers at power on as follows:

! DESER 255 (equivalent to a DESe 255 command)

! ESER 0 (equivalent to an *ESE 0 command)

! SRER 0 (equivalent to an *SRE 0 command)

Sending *PSC 0 lets the Enable Registers maintain their values in nonvolatile memory through a power

Note: To enable the PON (Power On) event to generate a Service Request, send *PSC 0, use the DESe

and *ESE commands to enable PON in the DESER and ESER, and use the *SRE command to enable bit

5 in the SRER. Subsequent power-on cycles will generate a Service Request.

Need help?

Do you have a question about the TDS7000 Series and is the answer not in the manual?