Command Error - Tektronix TDS7000 Series Programmer's Manual

Command Error

The following table shows the command error messages generated by improper syntax. Check that the
command is properly formed and that it follows the rules in the section on command Syntax.
C o m m a n d E r r o r M e s s a g e s ( C M E B i t 5 )
C o d e M e s s a g e
100 Command error
101 Invalid character
102 Syntax error
103 Invalid separator
104 Data type error
105 GET not allowed
108 Parameter not allowed
109 Missing parameter
110 Command header error
111 Header separator error
112 Program mnemonic too long
113 Undefined header
114 Header suffix out of range
120 Numeric data error
121 Invalid character in number
123 Exponent too large
124 Too many digits
128 Numeric data not allowed
130 Suffix error
131 Invalid suffix
134 Suffix too long
138 Suffix not allowed
140 Character data error
141 Invalid character data
144 Character data too long
148 Character data not allowed
150 String data error
151 Invalid string data
158 String data not allowed
160 Block data error
161 Invalid block data
168 Block data not allowed
170 Command expression error
171 Invalid expression
178 Expression data not allowed
532