Tektronix TDS7000 Series Programmer's Manual page 306

*SAV
Description
This command (no query form) stores the state of the oscilloscope to a specified memory location. You
can later use the *RCL command to restore the oscilloscope to this saved state. This is equivalent to
selecting Instrument Setup from the File menu and then choosing the Save Setups tab.
Group
Save and Recall
Related Commands
*RCL (see page 303), RECAll:SETUp (see page 309), SAVe:SETUp (see page 311)
Syntax
*SAV <NR1>
Argument
• <NR1>
This specifies a location in which to save the state of the scope. Location values range from 1 through
10. Using an out-of-range location value causes an execution error. Any settings that have been stored
previously at this location will be overwritten.
Example
*SAV 2
This command saves the current oscilloscope state in memory location 2.
304