Required Driver Parameters - Fujitsu ETERNUS DX Configuration Manual

Chapter 2 Setup Procedure for Emulex Fibre Channel Cards
2.5

Required Driver Parameters

Example 2: EFI disk labels
EFI labels are automatically assigned to 1TB and larger disks. However, even if the disk capacity is less
than 1TB, EFI labels can still be assigned using the "format -e" command, as shown in the following
example.
# format -e
Searching for disks...done
c5t16d0: configured with capacity of 3555.50GB
AVAILABLE DISK SELECTIONS:
0. c0t0d0 <FUJITSU-MAP3367NC-3701 cyl 12435 alt 2 hd 10 sec 574>
1. c5t16d0 <FUJITSU-ETERNUS_DX400-3.47TB>
Specify disk (enter its number): 1
selecting c5t16d0
[disk formatted]
format> label
[0] SMI Label
[1] EFI Label
Specify Label type[0]: 1
Ready to label disk, continue? yes
format> quit
2.5 Required Driver Parameters
The parameters in the "/kernel/drv/lpfc.conf" configuration file need to be edited as described below.
Required parameters and values vary depending on the version of Fibre Channel card driver being used.
Original configuration file must be backed up before editing.
Example:
cp /kernel/drv/lpfc.conf ./lpfc.conf.backup
Refer to the following notes for the settings:
These settings are common for all Solaris 10 OS, Solaris 9 OS, and Solaris 8 OS versions.
•
Comment out any items that are not required by putting a "#" at the beginning of the line.
•
Instance names are specified for some items, but not for others.
•
Check the "WWN instance management table for the server" for the actual "X" instance numbers to use in
the lpfcX.
FUJITSU Storage ETERNUS DX, ETERNUS AF Configuration Guide -Server Connection- (Fibre Channel) for Oracle Solaris
/pci@83,4000/FJSV,ulsa@2,1/sd@0,0
/pci@80,4000/lpfc@3/sd@10,0
40
Copyright 2017 FUJITSU LIMITED
P3AM-6312-18ENZ0