Creating A Wwn Instance Management Table For Storage System - Fujitsu ETERNUS DX Configuration Manual

Chapter 2 Setup Procedure for Emulex Fibre Channel Cards
2.3 Setting Up the Server
4
Add the results in the "WWN instance management table for the server".
Example:
Physical slot name
2.3.2

Creating a WWN Instance Management Table for Storage System

Create a "WWN instance management table for storage system" that summarizes information relating to CA
in the ETERNUS DX/AF storage systems.
WWN Instance Management Table for Storage System
Channel Adapter
Check the following items and enter them in the WWN instance management table for storage system.
Channel Adapter
•
CA name in the ETERNUS DX/AF storage systems
WWN
•
The WWN for each CA in the ETERNUS DX/AF (check using ETERNUSmgr)
T_ID
•
The SCSI target ID (decimal value) that is to be defined for each CA
For switch connections, the SCSI target ID is irrelevant to the physical protocol, however it must be defined
as a Solaris OS SCSI driver setting. Values matched to the server environment and connection state of the
devices must be set beforehand.
It is recommended to set the same target ID to CAs that configures a multipath.
(Example) When there are two ports on the ETERNUS DX/AF storage systems:
Channel Adapter
CM0CA0Port0
CM1CA0Port0
FUJITSU Storage ETERNUS DX, ETERNUS AF Configuration Guide -Server Connection- (Fibre Channel) for Oracle Solaris
WWN
10000000c9366046
10000000c9365d9e
WWN
WWN
202000e000cb0001
203000e000cb0001
33
Copyright 2017 FUJITSU LIMITED
Instance name
lpfc0
lpfc1
T_ID
Alias name
DX400_CM0CA0P0
DX400_CM1CA0P0
Physical path name
/pci@9,600000/lpfc@1
/pci@9,600000/lpfc@2
T_ID
16
16
P3AM-6312-18ENZ0