Fujitsu ETERNUS DX Configuration Manual page 78

Chapter 4 Operations When Using Brocade Fibre Channel Cards
4.3 Setting Up the Server
Port speed
•
Specify the port speed value according to the table below.
"bcu" command format
bcu port --speed <port_id> [ 1|2|4|8|16|10|auto]
Fibre Channel
card transfer rate
16Gbit/s
8Gbit/s
4Gbit/s
Topology
•
Set the topology value to "p2p".
"bcu" command format
bcu port --topology <port_id> [auto | p2p]
• Frame data size
Set the frame data size value to "2048".
"bcu" command format
bcu port --dfsize <port_id> [<dfsize>]
The following procedure shows an example for setting the port speed, topology, and frame data size.
1
Check the "port_id" of the target port.
# bcu port --list
Port#
1/0
1/1
The underlined portion indicates the port ID.
The port ID checked here is used to set the port speed, topology, and frame data size.
2
Set the port speed to "8G".
# bcu port --speed 1/0 8
Setting will be enforced after port --disable and -enable
FUJITSU Storage ETERNUS DX, ETERNUS AF Configuration Guide -Server Connection- (Fibre Channel) for Oracle Solaris
Fibre Channel switch transfer rate
16Gbit/s 8Gbit/s
16 8
8 8
4 4
Type PWWN/MAC
fc 10:00:00:05:1e:e7:45:7b
fc 10:00:00:05:1e:e7:45:7c
Copyright 2017 FUJITSU LIMITED
4Gbit/s
4
4
4
FC Addr/ Media
Eth dev
010400 sw
010500 sw
78
Direct connection
to Fibre Channel
cards
2Gbit/s 16Gbit/s CA
— —
2 —
2 —
State Spd
Linkup 8G
Linkup 8G
P3AM-6312-18ENZ0