Setting Up The Server To Recognize The Logical Units; Recognizing Logical Units With The Sd Driver - Fujitsu ETERNUS DX Configuration Manual

Chapter 2 Setup Procedure for Emulex Fibre Channel Cards
2.4

Setting Up the Server to Recognize the Logical Units

2.4 Setting Up the Server to Recognize the Logical Units
Make the server recognize the ETERNUS DX/AF logical units using the sd driver or hddv driver.
Skip this section if using the ETERNUS Multipath Driver or GR Multipath Driver "grmpdautoconf" command.
2.4.1

Recognizing Logical Units with the sd Driver

Make the server recognize the ETERNUS DX/AF logical units using the sd driver.
First, confirm that the logical unit settings on the ETERNUS DX/AF storage systems are correct. Next, add the
descriptions of the logical units in the sd driver's configuration file (sd.conf) to register the units.
Then reboot the server to get it to recognize the logical units.
When the Fibre Channel card driver version is V6.30g or later, skip this setting.
2.4.1.1 Logical Unit Recognition
The Emulex Fibre Channel card driver requires different settings, depending on the connection method (top-
ology).
●
For direct connection
Add the descriptions of the logical units in the sd driver configuration file (sd.conf) using a text editor, such
as "vi".
Solaris 11 OS
•
If the "/etc/driver/drv/sd.conf" file does not exist, copy the "/kernel/drv/sd.conf" file to the "/etc/driver/drv"
directory and add the line to the newly copied "sd.conf" file.
If the "/etc/driver/drv/sd.conf" file exists, do not copy over the file but instead add the line to the existing
"sd.conf" file.
Solaris 10 OS
•
Add the line to the "/kernel/drv/sd.conf" file.
Do not delete the lun=0 description for the system disk target ID.
FUJITSU Storage ETERNUS DX, ETERNUS AF Configuration Guide -Server Connection- (Fibre Channel) for Oracle Solaris
36
Copyright 2017 FUJITSU LIMITED
P3AM-6312-18ENZ0