Chapter 2
Setup Procedure for Emulex Fibre Channel Cards
2.3
Setting Up the Server
2.3.3
Creating a Target Binding Table
This procedure is not necessary for direct connections.
Target binding logically binds the Fibre Channel card installed in the server, and the CA on the ETERNUS
DX/AF storage systems to be connected to the server.
Target binding binds the instance name of the Fibre Channel card, channel adapter name, WWN, and target
ID.
Enter the required information for target binding in the "target binding table". Create "Target binding tables"
for each server to be connected.
Enter the following information in the target binding table.
Name of target server
•
Channel Adapter names and their SCSI target IDs
•
The "channel adapter names" and "target IDs" entered in the "WWN instance management table for stor-
age system"
RAID-WWN
•
The WWN entered in the "WWN instance management table for storage system"
1
Enter the target information to be set for the server.
Reflect the information from the "WWN instance management table for storage system" in the "target
binding table".
Target Binding Table
Server name: Server1
Channel Adapter name
CM0CA0
CM1CA0
2
Confirm the connection path(s) in the system.
Example:
Fibre Channel Switch A
CA0 Port0
Physical slots on Server#0 and CAs on the ETERNUS DX/AF storage systems are connected in the follow-
ing paths.
•
Server#0 SLOT0 - CM0CA0
•
Server#0 SLOT1 - CM1CA0
FUJITSU Storage ETERNUS DX, ETERNUS AF Configuration Guide -Server Connection- (Fibre Channel) for Oracle Solaris
SCSI T-ID
16
16
Server#0
Slot0
Slot1
Fibre Channel Switch B
CA0 Port1
CA0 Port0
CA0 Port1
CM0
CM1
ETERNUS DX/AF
Copyright 2017 FUJITSU LIMITED
RAID-WWN
202000c000cb0001
203000c000cb0001
34
Instance name
P3AM-6312-18ENZ0