Chapter 3
Setup Procedure for QLogic Fibre Channel Cards
3.3
Setting Up the Server
●
For switch connection
The Fibre Channel card Instance name, target WWN, and target ID information are necessary. Check each
item and enter them in the table. Edit the configuration file according to those information and make set-
tings. Refer to the following sections to set.
"3.3.1 Creating a WWN Instance Management Table for the Server" (page 56)
•
"3.3.2 Creating a WWN Instance Management Table for Storage System" (page 60)
•
"3.3.3 Creating a Target Binding Table" (page 61)
•
"3.3.4 Setting the Configuration File" (page 62)
•
•
"3.3.5 Re-checking the Settings" (page 62)
3.3.1
Creating a WWN Instance Management Table for the Server
Create a "WWN instance management table for the server" with information regarding the Fibre Channel
card.
Determine the following information for each Fibre Channel card installed in the server and enter it into a
copy of the "WWN instance management table for the server". (found in
Table Templates" (page
Physical slot name
•
WWN
•
Instance name
•
Physical path name
•
WWN instance management table for the server
Physical slot name
1
Check the instance names.
"hba + instance number" is the format used to represent Fibre Channel card instance names.
The instance number that corresponds to the physical path in which the Fibre Channel card is installed
is stored in the "/etc/path_to_inst" file at the Fibre Channel card driver installation.
Extract necessary parts using the "grep" command.
# grep "QLGC" /etc/path_to_inst
Example:
"/pci@b,2000/QLGC,qla@2
"/pci@b,2000/QLGC,qla@2, 1" 1 "qla2300"
The underlined portion "/pci@b,2000/QLGC,qla@2" indicates the physical path name, and "1" indicates
the instance number.
FUJITSU Storage ETERNUS DX, ETERNUS AF Configuration Guide -Server Connection- (Fibre Channel) for Oracle Solaris
82)).
WWN
" 0 "qla2300"
56
Copyright 2017 FUJITSU LIMITED
"Appendix A Various Management
Instance name
Physical path name
P3AM-6312-18ENZ0