Reset Button - Hirschmann BAT450-F User Manual

1.7.2

Reset button

The device has a reset button. The reset button is located behind a
screwable IP67 protection cap.
The tightening torque is 4.42 lb-in to 8.85 lb-in (0.5 Nm to 1.0 Nm).
Prerequisite: Keep the working area dry and clean when you are carrying
out a reset.
After pressing the reset button, replace the protection cap. Degrees of
protection IP65/67 are only achieved when the protection cap is closed.
You will find more information in the "User Manual Configuration Guide", in
the chapter "Using the Boot Configurations". The "User Manual Configuration
Guide" is available as PDF file on the Internet on the Hirschmann product
pages (www.hirschmann.com).
Installation BAT450-F
25
Release 06 08/2017