Hirschmann BAT450-F User Manual page 10

LED or laser components

LED or LASER components according to IEC 60825-1 (2014):
CLASS 1 LASER PRODUCT
CLASS 1 LED PRODUCT
FCC note:

This device complies with part 15 of the FCC rules.
Operation is subject to the following two conditions:
 This device may not cause harmful interference, and
 This device must accept any interference received, including
interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
 Reposition the receiver antenna or change the angle of the receiver
antenna.
 Increase the separation between the device and the receiver.
 Connect the device to a different outlet on a different power supply
cable from that to which the receiver is connected.
 Consult a specialist retailer or an electronic systems engineer for help.
Changes or modifications not expressly approved by the holder of the
certificate could void the user's authority to operate this equipment.
EWLAN1 Module
Note for the use in the USA and in Canada
The following section applies to device variants with characteristic
value US (USA/Canada) for country approvals, which are labeled as
follows:
Contains Transmitter Module
FCC ID: U99EWLAN1
IC: 4019A-EWLAN1
This equipment complies with FCC and IC RSS-102 radiation exposure
limits set forth for an uncontrolled environment. Install and operate this
equipment with a minimum distance of 19.7 in (50 cm) (related to a 9 dBi
antenna) between the radiation source and your body.
10
Installation BAT450-F
Release 06 08/2017