User Configuration; Firmware Updater Notification; Physical Reset Button - Hirschmann NetModule AP3400 User Manual

– Update automatically - when this is enabled, AP3400 will automatically update (without notifying
the user) when new firmware is available.
– "Check now" button - click if you want AP3400 to check for an update at that moment. Link:
https://share.netmodule.com/public/system-software/firmware/
– Firmware server URL - specify the server address where new firmware is published.
– Update button - this button will appear when a new update is available on the server:
– You will be notified by a popover dialog about the option to update. You can either click the
"Update" button in the popover, or update later in the System configuration page.

Physical reset button

AP3400 physical reset button has a capability to enable or disable the functioning of it.
5.2.5. User Configuration
In AP3400 you can additional users, give them different access of Admin, Installer, Observer.
– User name - must consist of 1-24 symbols. Special symbols are not valid.
– Roles:
– Admin - has root privileges, can access and change device parameters, make configuration
resets.
– Installer - only able to view parameters and install firmware on the device.
– Observer - user which can only view device parameters.
– Status - you can disable certain user without deleting them.
AP3400
Figure 5.40.: Firmware Updater Notification
Figure 5.41.: Physical Reset Button
Figure 5.42.: User Configuration
51 User Manual for version 1.9.1