Hirschmann BAT450-F User Manual page 11

The antenna used for this transmitter must not be co-located with any
other transmitters within a host device, except in accordance with FCC
multi-transmitter product procedures.
This transmitter is restricted to indoor use only within the
5.15 to 5.25 GHz band to reduce potential for harmful interference to co-
channel mobile satellite systems.
This Class B digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe B est conforme à la norme NMB-003
du Canada.
To reduce potential radio interference to other users, the antenna type
and its gain should be so chosen that the equivalent isotropically radiated
power (EIRP) is not more than that permitted for successful
communication.
This device has been designed to operate with the antennas listed below
in point-to-multipoint systems, and having a maximum gain of 9 dBi:
Antennas operating with this device
model:
BAT-ANT-RSMA-2AGN-R
BAT-ANT-N-3AGN-IP67
BAT-ANT-N-MiMoDB-5N-IP65
BAT-ANT-N-MiMo5-9N-IP65
BAT-ANT-N-8G-DS-IP65
The FCC approval is valid only in conjunction with the listed antennas. If
other antennas are used, the approval expires. The responsibility lies with
the operator of the system. The required antenna impedance is 50 Ω.
Note (1): When using 3 antennas type BAT-ANT-RSMA-2AGN-R, you
must align each antenna in another spatial direction (x-y-z) so that one
antenna is arranged vertically to the device and the other two antennas
are arranged at right angles to each other.
EWLAN2 Module
Note for the use in the USA and in Canada
The following section applies to device variants with characteristic
value US (USA/Canada) for country approvals, which are labeled as
follows:
Contains Transmitter Module
FCC ID: U99EWLAN2
IC: 4019A-EWLAN2
Installation BAT450-F
Release 06 08/2017
Permitted band of operation
2.4 GHz band
(1)
Yes
Yes
Yes
No
Yes
5.15 GHz ... 5.725 GHz ...
5.25 GHz band 5.825 GHz band
Yes Yes
Yes Yes
Yes Yes
Yes Yes
No No
11