Grounding The Device; Installing The Antennas - Hirschmann BAT450-F User Manual

2.2.3

Grounding the device

The device is grounded via the separate ground screw.
 Terminate the ground conductor between the fastening plates.
 Make sure the fastening plates cover the insulated part of the ground
conductor completely.
 Tighten the grounding screw with a tightening torque of
3 Nm ± 0.5 Nm (26.55 lb-in ± 4.43 lb-in).
2.3

Installing the antennas

The device has connections for external antennas. These connections are N
sockets.
Note: Applies exclusively to device variants with LTE module and the
antenna WWAN-A-I-41-S-O:
You need the adapter WWAN-N-O-N-S (N plug to SMA socket). The adapter
is included in the scope of delivery for device variants with the Configuration
characteristic value "Z" and available as accessory.
On delivery, the connections are sealed with protection caps.
Proceed as follows:
 Unscrew the protection caps from the connections to which you want to
connect external antennas.
 Install at least one antenna on the radio module that you would like to use.
 Use the provided terminating resistors to seal unused sockets to avoid
radio signals from one radio module being received by another radio
module. The terminating resistors are included in the scope of delivery for
device variants with the Configuration characteristic value "Z" and
available as accessory.
See "Scope of delivery, order numbers and accessories" on page 57.

You will find information on setting the transmit power in chapter
"Configuring the transmit power" on page
30
39.
Installation BAT450-F
Release 06 08/2017