Table of Contents
Advertisement
file:///G|/CSO/Documentation/Documentation%20-%20Draft/Networking/5454%20Mach-1%20AP/User%20Guide/English/trouble_upgrade.html
6. Specify a temporary static IP address for the computer's network adapter.
The IP address must be in the same subnet as the access point:
If the access point was acquiring its address dynamically, set the IP
address of your computer to 192.168.1.100.
If you assigned a static IP address to the access point, match the first three
parts of the IP address to the static address of the access point. For
example, if the static address of the access point is 192.168.3.1, set the IP
address of the computer to 192.168.3.100.
7. Click OK.
8. Click OK again.
9. Run the Device Locator to obtain the IP addresses of devices on your local
network. Match the MAC address printed on the bottom of the access point to the
addresses shown by the utility to find the access point's IP address.
10. On the Windows Start menu, click Run.
11. In the Run dialog box, type command and click OK.
12. Locate the folder that contains that firmware file that you downloaded.
13. Type cd followed by the path to the firmware file. Use quotation marks around
the pathname as shown in the following example:
cd "C:\networking\usr5454"
and then press ENTER.
14. Type the following command (but do not press ENTER)
tftp -i xxx.xxx.x.x put 5454.usr where xxx.xxx.x.x is the IP
address of the access point.
15. Disconnect and then reconnect the power supply of the access point.
file:///G|/CSO/Documentation/Documentation%20-%20Dra...ach-1%20AP/User%20Guide/English/trouble_upgrade.html (7 of 8)10/26/2006 9:47:15 AM
Advertisement
Table of Contents
