Table of Contents
Advertisement
file:///G|/CSO/Documentation/Documentation%20-%20Draft/Networking/5454%20Mach-1%20AP/User%20Guide/English/security.html
The access point configuration pages let you configure access to the access point based on
MAC addresses by using the Allow Current Clients button or specify a level of filter to
apply:
Click Allow Current Clients to allow all of the wireless clients currently connected to
the access point to be allowed access to the access point in the future. By default, the
filter setting of Allow only these devices will then be applied.
Allow all devices: Any wireless client that has the correct security information will
be allowed to connect to the access point. This is the default setting.
Allow only these devices: Allows only devices with specific MAC addresses to
establish a wireless connection with the access point.
1. Enter the MAC address of the device that should be allowed connection to the
access point.
2. Click Add.
Deny only these devices: Denies a wireless connection to the access point for
devices with the specified MAC addresses. This can be used if you notice unauthorised
wireless devices that are connected to your network.
1. Enter the MAC address of the device that should be denied connection to the
access point.
file:///G|/CSO/Documentation/Documentation%20-%20Dr...54%20Mach-1%20AP/User%20Guide/English/security.html (3 of 4)10/26/2006 9:47:09 AM
Advertisement
Table of Contents
