US Robotics USR5454 User Manual page 90

file:///G|/CSO/Documentation/Documentation%20-%20Draft/Networking/5454%20Mach-1%20AP/User%20Guide/English/trouble_wds.html
User Guide
Home
Installation
Configuration
Tutorials
Help
In bridge mode or range extender mode, the access point will
not connect to another networking device.
Solution:
If the WDS channel of the networking device that the access point is connected to
changes, the Status
access point. Although the Network list on the
network and the correct channel, the change has not yet been applied to the access
point. To update the channel information on the access point, click Save at the bottom
of the Wireless
Make sure the access point is using the same required
peer, including the Control channel and Bandwidth settings (under Transmission),
and the same wireless Security settings as the WDS peer.
Return to Troubleshooting page
file:///G|/CSO/Documentation/Documentation%20-%20Dr...20Mach-1%20AP/User%20Guide/English/trouble_wds.html (1 of 2)10/26/2006 9:47:15 AM
Wireless Nd1 Access Point:
page will continue to show the old channel information for the
page.
Wireless page will display the selected
Wireless settings as the WDS