Table of Contents
Advertisement
file:///G|/CSO/Documentation/Documentation%20-%20Draft/Networking/5454%20Mach-1%20AP/User%20Guide/English/trouble_client_comm.html
Solution:
The access point may not have received a valid IP address for your network. Check the
LAN configuration page of the access point.
If the IP address is set to Dynamic, make sure that the access point is connected
to a DHCP server.
If you use a static IP address verify that it is in the same subnet as your client's
IP address.
Solution:
The access point may not be responding. Try the following:
1. Reconnect by following the steps in
2. If you still are not communicating with the access point, restore the factory
default settings of the access point to reactivate it.
Note:
When you restore the factory default settings, the access point will
lose all custom settings.
To restore the factory default settings, use a small object such as a paper clip to
press in and hold the reset button on the back of the access point for 5 to 10
seconds.
3. After you restore the access point,
point, or, if you made a backup of your settings,
backup.
file:///G|/CSO/Documentation/Documentation%20-%20Dra...1%20AP/User%20Guide/English/trouble_client_comm.html (2 of 3)10/26/2006 9:47:13 AM
Connecting a Wireless
reconfigure the basic settings
restore the settings
Client.
of the access
by using the
Advertisement
Table of Contents
