Table of Contents
Advertisement
file:///G|/CSO/Documentation/Documentation%20-%20Draft/Networking/5454%20Mach-1%20AP/User%20Guide/English/trouble_upgrade.html
Perform the following steps to manually install the access point's firmware:
1. Use a networking cables to connect the access point directly to the computer. Do
not try to use a wireless connection for this procedure.
2. Determine the IP address to use for the access point:
A. If the most recent IP address of the access point was acquired dynamically,
use 192.168.1.64
B. If you assigned a static IP address to the access point, use the address that
you assigned. If you cannot remember the IP address that you assigned,
run the
subnet as the computer, the locator will find the access point.
3. On the desktop, right-click Network Places or Network Neighborhood and
select Properties.
4. On the Configuration tab, select the network adapter that connects the
computer to the router and click Properties.
5. Select Use the following IP address:
file:///G|/CSO/Documentation/Documentation%20-%20Dra...ach-1%20AP/User%20Guide/English/trouble_upgrade.html (6 of 8)10/26/2006 9:47:15 AM
Network Device
Locator. As long as the access point is in the same
Advertisement
Table of Contents
