Table of Contents
Advertisement
file:///G|/CSO/Documentation/Documentation%20-%20Draft/Networking/5454%20Mach-1%20AP/User%20Guide/English/trouble_upgrade.html
Windows XP, 2000, and NT users can also perform the following manual upgrade
procedure:
1. Use a networking cables to connect the access point directly to the computer. Do
not try to use a wireless connection for this procedure.
2. Determine the IP address to use for the access point:
A. If the most recent IP address of the access point was acquired dynamically,
use 192.168.1.64
B. If you assigned a static IP address to the access point, use the address that
you assigned. If you cannot remember the IP address that you assigned,
run the
subnet as the computer, the locator will find the access point.
3. On the Windows Start menu, select Run.
4. In the Run dialog box, type cmd and click OK.
5. Locate the folder that contains that firmware file that you downloaded.
6. Type cd followed by the path to the firmware file. Use quotation marks around
the pathname as shown in the following example:
file:///G|/CSO/Documentation/Documentation%20-%20Dra...ach-1%20AP/User%20Guide/English/trouble_upgrade.html (4 of 8)10/26/2006 9:47:15 AM
Network Device
Locator. As long as the access point is in the same
Advertisement
Table of Contents
