Table of Contents
Advertisement
file:///G|/CSO/Documentation/Documentation%20-%20Draft/Networking/5454%20Mach-1%20AP/User%20Guide/English/trouble_upgrade.html
cd "C:\networking\usr5454"
and then press ENTER.
7. Type the following command (but do not press ENTER)
tftp -i xxx.xxx.x.x put 5454.usr where xxx.xxx.x.x is the IP
address of the access point.
8. Disconnect and then reconnect the power supply of the access point.
9. Press ENTER.
You should see a message in the command window stating the image was
transferred.
10. Wait for the upgrade to finish. When the wireless LED
done.
11. Set IP addressing for the wired network adapter to "Obtain an IP address
automatically" as follows:
A. Open the Control Panel and double-click Network Connections.
B. Right-click the Local Area Connection of the network adapter that
connects the computer to the router and select Properties.
C. On the General tab, select Internet Protocol (TCP/IP) and click
Properties.
D. Select Obtain an IP Address Automatically and click OK.
E. Click OK again.
Return to Troubleshooting page
For Windows Me, 98, and 95
file:///G|/CSO/Documentation/Documentation%20-%20Dra...ach-1%20AP/User%20Guide/English/trouble_upgrade.html (5 of 8)10/26/2006 9:47:15 AM
turns on, the upgrade is
Advertisement
Table of Contents
