Specifying An Access Control Method; Setting The Maximum Number Of Concurrent 802.1X Users On A Port; Setting The Maximum Number Of Authentication Request Attempts - HPE Moonshot 45Gc Security Configuration Manual

Step
interface view.
3. Set the port authorization
state.

Specifying an access control method

Step
1. Enter system view.
2. Enter Layer 2 Ethernet
interface view.
3. Specify an access control
method.
Setting the maximum number of concurrent
802.1X users on a port
Perform this task to prevent the system resources from being overused.
To set the maximum number of concurrent 802.1X users on a port:
Step
1. Enter system view.
2. Enter Layer 2 Ethernet
interface view.
3. Set the maximum number of
concurrent 802.1X users on
a port.
Setting the maximum number of authentication
request attempts
The access device retransmits an authentication request if it does not receive any responses to the
request from the client within a period of time. To set the time, use the dot1x timer tx-period
tx-period-value command or the dot1x timer supp-timeout supp-timeout-value command. The
access device stops retransmitting the request if it has made the maximum number of request
transmission attempts but still receives no response.
To set the maximum number of authentication request attempts:
Step
1. Enter system view.
2. Set the maximum number of attempts
for sending an authentication request.
Command
interface-number
dot1x port-control
{ authorized-force | auto |
unauthorized-force }
Command
system-view
interface interface-type
interface-number
dot1x port-method { macbased
| portbased }
Command
system-view
interface interface-type
interface-number
dot1x max-user user-number
Command
system-view
dot1x retry max-retry-value
82
Remarks
By default, the auto state
applies.
Remarks
N/A
N/A
By default, MAC-based access
control applies.
Remarks
N/A
N/A
The default setting is
4294967295.
Remarks
N/A
The default setting is
2.