Configuring An Ike-Based Ipsec Policy - HPE Moonshot 45Gc Security Configuration Manual

Configuring an IKE-based IPsec policy

In an IKE-based IPsec policy, the parameters are automatically negotiated through IKE.
To configure an IKE-based IPsec policy, use one of the following methods:
•
Directly configure it by configuring the parameters in IPsec policy view.
•
Configure it by referencing an existing IPsec policy template with the parameters to be
negotiated configured.
A device referencing an IPsec policy that is configured in this way cannot initiate an SA
negotiation, but it can respond to a negotiation request. The parameters not defined in the
template are determined by the initiator. When the remote end's information (such as the IP
address) is unknown, this method allows the remote end to initiate negotiations with the local
end.
Configuration restrictions and guidelines
Make sure the IPsec configuration at the two ends of an IPsec tunnel meets the following
requirements:
•
The IPsec policies at the two tunnel ends must have IPsec transform sets that use the same
security protocols, security algorithms, and encapsulation mode.
•
The IPsec policies at the two tunnel ends must have the same IKE profile parameters.
•
An IKE-based IPsec policy can reference up to six IPsec transform sets. During an IKE
negotiation, IKE searches for a fully matched IPsec transform set at the two ends of the IPsec
tunnel. If no match is found, no SA can be set up, and the packets expecting to be protected will
be dropped.
•
The remote IP address of the IPsec tunnel is required on an IKE negotiation initiator and is
optional on the responder. The remote IP address specified on the local end must be the same
as the local IP address specified on the remote end.
For an IPsec SA established through IKE negotiation:
•
The IPsec SA uses the local lifetime settings or those proposed by the peer, whichever are
smaller.
•
The IPsec SA can have both a time-based lifetime and a traffic-based lifetime. The IPsec SA
expires when either lifetime expires.
Directly configuring an IKE-based IPsec policy
Step
1. Enter system view.
2. Create an IKE-based IPsec
policy entry and enter its
view.
3. (Optional.) Configure a
description for the IPsec
policy.
4. Specify an ACL for the IPsec
policy.
5. Specify IPsec transform sets
for the IPsec policy.
Command
system-view
ipsec { ipv6-policy | policy }
policy-name seq-number isakmp
description text
security acl [ ipv6 ] { acl-number |
name acl-name } [ aggregation |
per-host ]
transform-set
transform-set-name&<1-6>
268
Remarks
N/A
By default, no IPsec policy exists.
By default, no description is
configured.
By default, no ACL is specified for
the IPsec policy.
An IPsec policy can reference
only one ACL.
By default, the IPsec policy
references no IPsec transform
set.