Ike Configuration Examples; Main Mode Ike With Pre-Shared Key Authentication Configuration Example - HPE Moonshot 45Gc Security Configuration Manual

Task
Delete IKE SAs.
Clear IKE MIB statistics.

IKE configuration examples

Main mode IKE with pre-shared key authentication
configuration example
Network requirements
As shown in
Switch B to secure the communication.
Configure Switch A and Switch B to use the default IKE proposal for the IKE negotiation to set up the
IPsec SA. Configure the two switches to use the pre-shared key authentication method.
Figure 91 Network diagram
Configuration procedure
Make sure Switch A and Switch B can reach each other.
1. Configure Switch A:
# Assign an IP address to VLAN-interface 1.
<SwitchA> system-view
[SwitchA] interface vlan-interface 1
[SwitchA-vlan-interface1] ip address 1.1.1.1 255.255.0.0
[SwitchA-vlan-interface1] quit
# Configure ACL 3101 to identify traffic between Switch A and Switch B.
[SwitchA] acl number 3101
[SwitchA-acl-adv-3101] rule 0 permit ip source 1.1.1.1 0 destination 2.2.2.2 0
[SwitchA-acl-adv-3101] quit
# Create IPsec transform set tran1.
[SwitchA] ipsec transform-set tran1
# Set the packet encapsulation mode to tunnel.
[SwitchA-ipsec-transform-set-tran1] encapsulation-mode tunnel
# Use the ESP protocol for the IPsec transform set.
[SwitchA-ipsec-transform-set-tran1] protocol esp
# Specify the encryption and authentication algorithms.
[SwitchA-ipsec-transform-set-tran1] esp encryption-algorithm aes-cbc-192
[SwitchA-ipsec-transform-set-tran1] esp authentication-algorithm sha1
[SwitchA-ipsec-transform-set-tran1] quit
# Create IKE keychain keychain1.
Figure 91, configure an IPsec tunnel that uses IKE negotiation between Switch A and
Command
connection-id | remote-address [ ipv6 ]
remote-address [ vpn-instance vpn-name ] ] ]
reset ike sa [ connection-id connection-id ]
reset ike statistics
299