Table of Contents
Advertisement
Configuring parameters for a user profile
Configurations in user profile view take effect only after the device applies the user profile to the user.
Configuring QoS parameters for traffic management
To configure QoS parameters:
Step
1.
Enter system view.
2.
Enter user profile view.
3.
Apply a QoS policy
Displaying and maintaining user profiles
Execute display commands in any view.
Task
Display configuration and online user information
for the specified user profile or all user profiles.
User profile configuration examples
Local 802.1X authentication/authorization with QoS policy
configuration example
Network requirements
As shown in
for User A, User B, and User C.
Configure user profiles for the users and apply a QoS policy to each user to implement the following
functions:
•
Deny User A's access to the network from 8:30 to 12:00 daily.
•
Limit the outgoing traffic rate to 2000 kbps for User B.
•
Limit the incoming traffic rate to 4000 kbps for User C.
Command
system-view
user-profile profile-name
qos apply policy policy-name
{ inbound | outbound }
Figure
137, the access switch performs local 802.1X authentication and authorization
Command
display user-profile [ name profile-name ] [ slot
slot-number ]
447
Remarks
N/A
N/A
The QoS policy must already
exist.
For information about QoS policy
configuration, see ACL and QoS
Configuration Guide.
For information about the
commands, see ACL and QoS
Command Reference.
Advertisement
Table of Contents
Troubleshooting
