Table 5. Table 2 40G QSFP+ transceiver modules available for the QSFP+ ports (1) Product Central HPE description Connector code wavelength (nm) HPE X140 40G QSFP+ MPO SR4 JG325B Transceiver HPE X140 40G QSFP+ MPO MM JG709A 850nm CSR4 300m Transceiver...
Page 3
9/125 Table 4 40G QSFP+ cables available for the QSFP+ ports Product HPE description Cable length Data rate code HPE X240 40G QSFP+ JG326A QSFP+ 1m Direct Attach 1 m (3.28 ft) 40 Gbps Copper Cable HPE X240 40G QSFP+...
Page 4
5 m (16.40 ft) 40 Gbps Attach Copper Splitter Cable NOTE: • When you install the interface module on the HPE FlexFabric 5930 4-Slot Switch (JH179A), HPE FlexFabric 5930 4-Slot TAA Switch (JH188A), and HPE FlexFabric 5940 4-Slot Switch (JH398A) the 40-GE QSFP+ ports on the interface modules cannot be split into four 10-GE SFP+ ports.
Page 5
LEDs Table 6 describes 1/10GBASE-T autosensing Ethernet port LEDs. Table 7 describes QSFP+ port LEDs. Table 6 1/10GBase-T autosensing Ethernet port LED description LED status Description Steady green The port has a link and is operating at 10 Gbps. Flashing green The port is sending or receiving data at 10 Gbps.
▌Installing and removing the interface module CAUTION: • Before you install or remove the interface module, wear an ESD wrist strap and make sure the strap makes good skin contact and is reliably grounded. • To avoid device damage, do not use excessive force when you install or remove the interface module.
Figure 3 Installing the LSWM124XGT2Q interface module Removing the interface module CAUTION: • Before you remove the interface module, remove the cable from it to avoid cable damage. • If you are not to install a new interface module,, install a filler panel in the slot to prevent dust and ensure good ventilation in the device.
Installing and removing QSFP+ transceiver modules and cables For information about installing and removing QSFP+ transceiver modules and cables, see HPE Transceiver Modules and Network Cables Installation Guide. Verifying the installation After the installation is complete, identify whether the interface module is operating correctly.