Troubleshooting Port Security; Cannot Set The Port Security Mode - HPE Moonshot 45Gc Security Configuration Manual

Max 802.1X users
Online 802.1X users
FortyGigE1/1/1
802.1X authentication
Handshake
Handshake reply
Handshake security
Unicast trigger
Periodic reauth
Port role
Authorization mode
Port access control
Multicast trigger
Mandatory auth domain
Guest VLAN
Auth-Fail VLAN
Critical VLAN
Critical voice VLAN
Re-auth server-unreachable : Logoff
Max online users
Send Packets Without Tag
Add Guest VLAN delay
EAPOL packets: Tx 16331, Rx 102
Sent EAP Request/Identity packets : 16316
EAP Request/Challenge packets: 6
EAP Success packets: 4
EAP Failure packets: 5
Received EAPOL Start packets : 6
Online 802.1X users: 1
# Verify that frames with an unknown destination MAC address, multicast address, or broadcast
address are discarded. (Details not shown.)

Troubleshooting port security

Cannot set the port security mode

Symptom
Cannot set the port security mode for a port.
Analysis
For a port operating in a port security mode other than noRestrictions, you cannot change the port
security mode by using the port-security port-mode command.
: 4294967295 per slot
: 1
is link-up
: Enabled
: Enabled
: Enabled
: Disabled
: Disabled
: Disabled
: Authenticator
: Auto
: MAC-based
: Enabled
: Not configured
: Not configured
: Not configured
: Not configured
: Disabled
: 4294967295
: Disabled
: Disabled
EAPOL LogOff packets: 2
EAP Response/Identity packets : 80
EAP Response/Challenge packets: 6
Error packets: 0
203