HPE Moonshot 45Gc Security Configuration Manual page 42

Step
Enabling the RADIUS server load sharing feature
By default, the device communicates with RADIUS servers based on the server roles. It first attempts
to communicate with the primary server, and, if the primary server is unavailable, it then searches for
the secondary servers in the order they are configured. The first secondary server in active state is
used for communication. In this process, the workload is always placed on the active server.
Use the RADIUS server load sharing feature to dynamically distribute the workload over multiple
servers regardless of their server roles. The device forwards an AAA request to the most appropriate
server of all active servers in the scheme after it compares the weight values and numbers of
currently served users. Specify a weight value for each RADIUS server based on the AAA capacity of
the server. A larger weight value indicates a higher AAA capacity.
In RADIUS server load sharing, once the device sends a start-accounting request to a server for a
user, it forwards all subsequent accounting requests of the user to the same server. If the accounting
server is unreachable, the device returns an accounting failure message rather than searching for
another active accounting server.
To enable the RADIUS server load sharing feature:
Step
1. Enter system view.
2. Enter RADIUS scheme
view.
3. Enable the RADIUS
server load sharing
feature.
Specifying the source IP address for outgoing RADIUS packets
The source IP address of RADIUS packets that a NAS sends must match the IP address of the NAS
configured on the RADIUS server. A RADIUS server identifies a NAS by its IP address. Upon
receiving a RADIUS packet, a RADIUS server checks whether the source IP address of the packet is
the IP address of a managed NAS.
•
If the source IP address of the packet is the IP address of a managed NAS, the server
processes the packet.
•
If the source IP address of the packet is not the IP address of a managed NAS, the server drops
the packet.
Command
* ] { active | block }
Command
system-view
radius scheme
radius-scheme-name
algorithm loading-share
enable
29
Remarks
Remarks
N/A
N/A
By default, this feature is disabled.