HPE Moonshot 45Gc Security Configuration Manual page 282

Step
6. Specify an IKE profile for the
IPsec policy.
7. Specify an IKEv2 profile for
the IPsec policy.
8. Specify the local IP address
of the IPsec tunnel.
9. Specify the remote IP
address of the IPsec tunnel.
10. Set the IPsec SA lifetime.
11. (Optional.) Set the IPsec SA
idle timeout.
12. (Optional.) Enable the Traffic
Flow Confidentiality (TFC)
padding feature.
13. Return to system view.
14. Set the global SA lifetime.
15. (Optional.) Enable the global
IPsec SA idle timeout
feature, and set the global
SA idle timeout.
Command
ike-profile profile-name
ikev2-profile profile-name
local-address { ipv4-address |
ipv6 ipv6-address }
remote-address { [ ipv6 ]
host-name | ipv4-address | ipv6
ipv6-address }
sa duration { time-based
seconds | traffic-based
kilobytes }
sa idle-time seconds
tfc enable
quit
ipsec sa global-duration
{ time-based seconds |
traffic-based kilobytes }
ipsec sa idle-time seconds
269
Remarks
By default, the IPsec policy
references no IKE profile, and the
device selects an IKE profile
configured in system view for
negotiation. If no IKE profile is
configured, the globally
configured IKE settings are used.
An IPsec policy can reference
only one IKE profile, and it cannot
reference any IKE profile that is
already referenced by another
IPsec policy or IPsec policy
template.
For more information about IKE
profiles, see "Configuring
By default, no IKEv2 profile is
specified for an IPsec policy.
You can specify only one IKEv2
profile for an IPsec policy.
For more information about IKEv2
profiles, see "Configuring
By default, the local IPv4 address
of IPsec tunnel is the primary IPv4
address of the interface to which
the IPsec policy is applied, and
the local IPv6 address of the
IPsec tunnel is the first IPv6
address of the interface to which
the IPsec policy is applied.
The local IP address specified by
this command must be the same
as the IP address used as the
local IKE identity.
By default, the remote IP address
of the IPsec tunnel is not
specified.
By default, the global SA lifetime
is used.
By default, the global SA idle
timeout is used.
By default, the TFC padding
feature is disabled.
N/A
By default, the time-based SA
lifetime is 3600 seconds, and the
traffic-based SA lifetime is
1843200 kilobytes.
By default, the global IPsec SA
idle timeout feature is disabled.
IKE."
IKEv2."