Table of Contents
Advertisement
Enabling portal roaming
Portal roaming takes effect only on portal users logging in from VLAN interfaces.
If portal roaming is enabled on a VLAN interface, an online portal user can access resources from
any Layer 2 port in the VLAN without re-authentication.
If portal roaming is disabled, to access external network resources from a Layer 2 port different from
the current access port in the VLAN, the user must do the following:
•
First log out from the current port.
•
Then re-authenticate on the new Layer 2 port.
To enable portal roaming:
Step
1.
Enter system view.
2.
Enable portal roaming.
Logging out portal users
Logging out a user terminates the authentication process for the user or removes the user from the
authenticated users list.
To log out users:
Step
1.
Enter system view.
2.
Log out IPv4 portal users.
3.
Log out IPv6 portal users.
Configuring the local portal Web server feature
To perform local portal authentication for users, perform the following tasks:
•
Configure a local portal Web server.
•
Configure a name for the portal Web server and specify a local IP address of the device as the
server's URL.
•
Enable portal authentication on the user access interface.
•
Specify the portal Web server on the portal-enabled interface.
During local portal authentication, the local Web portal server pushes authentication pages to users.
You must customize the authentication pages and upload them to the device. On the device, specify
an authentication page file as the default authentication page file for local portal authentication.
Command
system-view
portal roaming enable
Command
system-view
portal delete-user { ipv4-address | all | interface interface-type
interface-number }
portal delete-user { all | interface interface-type interface-number |
ipv6 ipv6-address }
142
Remarks
N/A
By default, portal roaming is
disabled.
You cannot enable portal roaming
when login users exist on the
device.
Advertisement
Table of Contents
Troubleshooting
