Verifying The Configuration - HPE Moonshot 45Gc Security Configuration Manual

[Switch] netconf ssh server enable
# Configure an IP address for VLAN-interface 2. The client uses this address as the destination for
NETCONF-over-SSH connection.
[Switch] interface vlan-interface 2
[Switch-Vlan-interface2] ip address 192.168.1.40 255.255.255.0
[Switch-Vlan-interface2] quit
# Set the authentication mode to AAA for the user lines.
[Switch] line vty 0 63
[Switch-line-vty0-63] authentication-mode scheme
[Switch-line-vty0-63] quit
# Create a local device management user client001.
[Switch] local-user client001 class manage
# Specify the plaintext password as aabbcc and the service type as ssh for the user.
[Switch-luser-manage-client001] password simple aabbcc
[Switch-luser-manage-client001] service-type ssh
# Assign the user role network-admin to the user.
[Switch-luser-manage-client001] authorization-attribute user-role network-admin
[Switch-luser-manage-client001] quit
# Configure an SSH user client001. Specify the service type as NETCONF and the authentication
method as password for the user. By default, password authentication is used if no SSH user is
created.
[Switch] ssh user client001 service-type netconf authentication-type password

Verifying the configuration

# Verify that you can perform NETCONF operations after logging in to the switch. (Details not
shown.)
384