Configuring Re-Dhcp Portal Authentication - HPE Moonshot 45Gc Security Configuration Manual

Server type
--
Layer3 source network:
IP address
Destination authenticate subnet:
IP address
IPv6:
Portal status: Disabled
Authentication type: Disabled
Portal Web server: Not configured
Authentication domain: Not configured
Bas-ipv6: Not configured
User detection: Not configured
Action for server detection:
Server type
--
Layer3 source network:
IP address
Destination authenticate subnet:
IP address
A user can perform portal authentication by using the HPE iNode client or a Web browser. Before
passing the
http://192.168.0.111:8080/portal and all Web requests will be redirected to the authentication page.
After passing the authentication, the user can access Internet resources.
# After the user passes authentication, use the following command to display information about the
portal user.
[Switch] display portal user interface vlan-interface 100
Total portal users: 1
Username: abc
Portal server: newpt
State: Online
Authorization ACL: --
VPN instance: --
MAC
0015-e9a6-7cfe

Configuring re-DHCP portal authentication

Network requirements
As shown in
obtains an IP address through the DHCP server. A portal server acts as both a portal authentication
server and a portal Web server. A RADIUS server acts as the authentication/accounting server.
Configure re-DHCP portal authentication. Before passing the authentication, the host is assigned a
private IP address. After passing the authentication, the host gets a public IP address and can
access Internet resources.
Server name
--
Server name
--
authentication, the
IP
2.2.2.2
Figure 53, the host is directly connected to the switch (the access device). The host
Mask
Mask
user can access
VLAN Interface
100 Vlan-interface100
153
Action
--
Action
--
Prefix length
Prefix length
only the authentication page