Table of Contents
Advertisement
WWW.SEAGULLMODELS.COM
The propeller should not touch any part
of the spinner cone. If it does, use a sharp
Speed Control.
modeling knife and carefully trim away the
spinner cone where the propeller comes in
contact with it.
.
Tie wraps.
INSTALLING THE AILERON - FLAP
SERVOS.
Battery.
Servos .
Small weight.
INSTALLING THE SPINNER.
Install the spinner backplate, propeller and
spinner cone.
Thread .
Because the size of servos differ, you may
need to adjust the size of the precut opening in
the mount. The notch in the sides of the mount
allow the servo lead to pass through.
15 15
Advertisement
Table of Contents
