Seagull Models SuperDave MX2 Assembly Manual page 8

SUPER DAVE MX2
INSTALLING THE MAIN LANDING
GEAR TO FUSELAGE.
1) The blind nuts for securing the landing
gear are already mounted inside the fuselage.
2) Using the hardware provided, mount the
main landing gear to the fuselage.
3) Place the fuselage inverted on the work-
bench in a suitable stand. Set the landing gear
in place and use a screwdrive to secure the
landing gear to the fuselage using bolts
M4x20mm and washers. Make sure to use
the threadlock on the bolts so they don't vi-
brate loose.
8 8
M4x20m m
Thread locker glue.
Instruction Manual.
M4x20mm
WHEEL AND WHEEL PANTS.
1) Locate the items neccessary to install.
2) Follow diagram below for wheel pant in-
stallation:
Use a drill and 8mm drill bit to drill a hole in
the wheel pants.
Drill a hole
8mm.
14mm.
3) You have to trim each axle using a tool
cutting and cut-off wheel.
4) Slide the collar to the axle and setscrew
the collars to secure the collar to the axle and
then slider the wheel on the axle with a drop
of oil on the axle so the wheel will spin freely
when installed. Prepare a second collar and
tighten the setscrew using hex wrench to se-
cure the collar to the axle.
5) Place the wheel assembly in the wheel
pants. The threaded portion of the axle will
fit the notch of the wheel pant as shown.