Installing The Aileron - Flap Servos - Seagull Models ZERO MS:123 Assembly Manual

The propeller should not touch any part
of the spinner cone. If it does, use a
sharp modeling knife and carefully trim away
the spinner cone where the propeller comes
in contact with it.

INSTALLING THE AILERON - FLAP SERVOS.

Servos.
Because the size of servos differ, you
may need to adjust the size of the precut open-
ing in the mount. The notch in the sides of
the mount allow the servo lead to pass through.
1) Using a small weight (
) and string, feed the string through
works well
the wing as indicated.
Small weight.
2) Place the servo between the mounting
blocks and space it from the hatch. Use a pencil
to m ark t he m ounting h ole l ocations o n t he
blocks.
www.seagullmodels.com
Small weight.
Thread.
Weighted fuel pick-up
String.
3) Use drill bit in a pin vise to drill the mouting
holes in the blocks.
4) Apply 2-3 drops of thin C/A to each of the
mounting holes. Allow the C/A to cure without
using accelerator.
5) Use dental floss to secure the connection
so they cannot become unplugged.
17