YASKAWA SGDV User Manual page 68

3 Wiring and Connection
3.2.2 Connecting to SGDV-
SGDV-
Power supply
Three-phase 400 VAC
Molded-case
circuit breaker
(MCCB)
Protects the power supply
line by shutting the
circuit OFF when
overcurrent is
detected.
Noise filter
Used to eliminate
external noise from
the power line.
Magnetic
contactor
Turns the servo
ON and OFF.
Install a surge
absorber.
100/200 VAC
Regenerative
resistor
Brake power
supply*
Used for a
servomotor
with a 90 V brake.
Magnetic contactor
Turns the brake power supply
ON and OFF.
Install a surge absorber.
∗1.
∗2.
∗3.
3-10
11
D11A
R S T
SGDV-
SERVOPACK
DC power
supply (24 V)*
1
*2
3
SGMGV/SGMSV
Servomotor
Use a 24 VDC power supply with double insulation or reinforced insulation. (The power
supply is not included)
Before connecting an external regenerative resistor to the SERVOPACK, refer to 3.4 Con-
necting Regenerative Resistors.
Use a following power supply for 90 V brake. For details, refer to
alog (KAEP S800000 42).
• For 200 V input voltage: LPSE-2H01-E
• For 100 V input voltage: LPDE-1H01-E
SERVOPACK (M-II Model)
D11A
Connect to the
MECHATROLINK-II
Connection cable
for digital operator
Connection cable
for personal computer
I/O signal cable
Battery case
(when an absolute
encoder is used.)
Motor main
circuit cable
Digital
operator
Personal
computer
Host controller
When not using the safety
function, use the SERVOPACK
with the safety function jumper
connector (JZSP-CVH05-E,
provided as an accessory)
inserted.
When using the safety function,
insert a connection cable
specifically for the safety function.
Safety function
devices
Encoder cable
Σ
-V series Product Cat-