YASKAWA SGDV User Manual page 71

• Using a Single-phase, 200-V Power Supply
The Σ-V Series SERVOPACK for a 200-V power supply input has input specifica-
tions for a three-phase power supply, but some models can also be used with a single-
phase 200-V power supply. For details, refer to
Maintenance Rotational Motor/MECHATROLINK-III Communications Reference
(manual no.: SIEP S800000 64).
Power supply
Single-phase 200 VAC
R T
Molded-case
circuit breaker
(MCCB)
Protcts the power supply
line by shutting the
circuit OFF when
overcurrent is detected.
Noise filter
Used to eliminate
external noise from
the power line.
Magnetic contactor
Turns the servo
ON and OFF.
Install a surge
absorber.
Regenerative
∗2
resistor
200 VAC
Brake power supply
Used for a servomotor
with a brake.
Magnetic contactor
Turns the brake power supply
ON and OFF.
Install a surge absorber.
∗1.
Use a 24 VDC power supply (not included.).
∗2.
Before connecting an external regenerative resistor to the SERVOPACK, refer to 3.4 Con-
necting Regenerative Resistors.
SGDV-
SERVOPACK
∗1
SGMJV/SGMAV/SGMPS/
SGMGV/SGMSV
Servomotor
3.2 System Configuration Diagram
Σ
-V Series User's Manual Design and
A21
Connect to the
MECHATROLINK-III.
Connection cable
for digital operator
Connection cable
for personal computer
I/O signal cable
Battery case
(when an absolute
encoder is used.)
Motor main
circuit cable
Digital
operator
Personal
computer
Host controller
When not using the safety
function, use the SERVOPACK
with the safety function jumper
connector (JZSP-CVH05-E,
provided as an accessory)
inserted.
When using the safety function,
insert a connection cable
specifically for the safety function.
Safety function
devices
Encoder cable
3
3-13